Selecting a channel

There are three ways of tuning in a channel:
• Using the left and right arrow keys to go to the next channel. Skipped channels (see page 221) will be excluded.
• By turning the TUNE control and selecting a channel from the list.
• Through direct channel entry.
NOTE
• The numbers of skipped or locked
channels will not be displayed.
• If a channel is locked, the access code
must be entered before the channel can
be selected. See "Unlocking a channel"
on page 221.
See also:
Brake pad inspection
On vehicles equipped with a jack*, the condition
of the brake pads can be checked by raising
the vehicle (see page 306 for information
about using the jack and removing a wheel)
and performing ...
Components in the SIPS airbag system
This SIPS airbag system consists of a gas generator, the side airbag modules
built into the outboard sides of both front seat backrests, and electronic sensors/wiring.
WARNING
The SIPS air ...
Oil pressure warning light
If the light comes on while
driving,
stop the vehicle and then
stop the engine immediately and
check the engine oil level. If the light stays on after
restart, have the vehicle towed to the nea ...
