Cleaning the sensors
Location of the front sensors
Location of the rear sensors
The sensors must be cleaned regularly to ensure that they work properly. Clean them with water and a suitable car washing detergent.
Ice and snow covering the sensors may cause incorrect warning signals.
NOTE
If the sensors are obstructed by e.g., dirt,
snow, or ice, this could result in false warning
signals from the park assist system.
See also:
Economical driving conserves natural resources
Better driving economy may be obtained by thinking ahead, avoiding rapid starts
and stops and adjusting the speed of your vehicle to immediate traffic conditions.
Observe the following rules:
B ...
Bluetooth® functions in the center console control panel
Character keys containing letters and numbers for dialing numbers, adding
phone book entries, etc.
TEL: Press this button to activate/deactivate the Bluetooth function.
TUNE: Turn to navig ...
Brake fluid reservoir
The brake fluid should always be above the
MIN mark on the side of the reservoir. Check,
without removing the cap, that there is sufficient
fluid in the reservoir.
Fluid type: DOT 4+ boiling poi ...