Applying the electric parking brake
Parking brake control
1. Press firmly on the brake pedal.
2. Push the control.
> The symbol in the instrument panel flashes while the parking bake is being applied, and glows steadily when the parking brake has been fully applied.
3. Release the brake pedal and ensure that the vehicle is at a standstill.
4. When the vehicle is parked, the gear selector must be in position P.
NOTE
• In an emergency the parking brake can
be applied when the vehicle is moving
by holding in the control. Braking will be
interrupted when the accelerator pedal
is depressed or the control is released.
• An audible signal will sound during this
procedure if the vehicle is moving at
speeds above 6 mph (10 km/h).
See also:
Limitations
Distance Alert uses the same radar sensor used by Adaptive Cruise Control and
the Collision Warning system. See page 160 for more information on the radar sensor’s
limitations.
NOTE
Strong ...
Practical loading area
The loading area has a lockable load floor covering two storage areas, one
for personal items and another for soiled or wet items. The load cover extends
over the entire loading area. The rear doo ...
Calibration
The compass may need to be calibrated if, for
example, the vehicle is driven into a new magnetic
zone. The character C is shown in the
mirror's display if calibration is necessary.
1. Stop the ...