Calibration
The compass may need to be calibrated if, for example, the vehicle is driven into a new magnetic zone. The character C is shown in the mirror's display if calibration is necessary.
1. Stop the vehicle in a large open area, safely out of traffic and away from steel structures and high-tension electrical wires.
2. Start the vehicle.
NOTE
For best results from calibration, switch off
all electrical equipment in the vehicle (climate
system, windshield wipers, audio system,
etc.) and make sure that all doors are
closed.
3. Using a pen or similar object, press and hold the button on the underside of mirror until C is shown again in the mirror(after approx. 6 seconds).
4. Drive as usual. C disappears from the display when calibration is complete.
Alternative calibration method:
Drive slowly in a circle at a speed of no more than 5 mph (8 km/h) until C disappears from the display when calibration is complete.
See also:
Introduction
The RSE system provides entertainment for the
rear seat passengers by making it possible to
e.g., watch a film, play music, listen to the radio
or connect an external device such as a game
con ...
Two wood inlays
Two different wood inlays are available: Classic Wood and Nordic Light Oak.
The standard base theme is called Charcoal, and another inlay theme is called
Brushed Aluminium.
Power tailgate
The o ...
Increasing or decreasing speed
Use + or – in the following ways to increase or
decrease the vehicle's speed:
1. Press and hold down + or – until the vehicle
reaches the desired speed.
2. Press + or – for approximately a hal ...