Buttons on the remote

Lock – Press
the Lock button on the
remote once to lock all doors and the tailgate.
The turn signals will flash once to confirm locking.
Unlock –
Press the Unlock button on the
remote once to unlock the driver's door.
After a short pause, press the Unlock button a second time within 10 seconds to unlock the other doors and the tailgate.
This function can be changed so that all doors
unlock at the same time by pressing My Car
and going to Settings
Car settings
Lock settings
Change doors unlock
setting. See page 133 for a description of the
menu system.
Approach
lighting – As you approach the
vehicle, press the button on the remote key to
light the interior lighting, parking lights, license
plate lighting and the lights in the door mirrors*.
These lights will switch off automatically after 30, 60 or 90 seconds. See page 133 for a description of the menu system.
Unlock
tailgate – Press the button twice
within several seconds to disarm the alarm
system and optional movement sensor (the
alarm indicator light on the dashboard will go
out), and unlock only the tailgate. Pressing this
button for several seconds also opens the tailgate
on models equipped with the optional
power tailgate.
NOTE
As an added safety precaution, the parking
lights will come on automatically for a short
period when the tailgate has been opened.
After closing, the tailgate will not automatically relock. Press Lock to relock it and rearm the alarm.
See also the section "Unlocking the tailgate from the passenger compartment."
Panic alarm –
This button can be used to
attract attention during emergency situations.
To activate the panic alarm, press and hold this button for at least 3 seconds or press it twice within 3 seconds. The turn signals and horn will be activated. The panic alarm will stop automatically after 2 minutes and 45 seconds.
To deactivate, wait approximately 5 seconds and press the button again.
The Panic alarm button will not unlock the vehicle.
See also:
Entering the third row of seats
Tilting the outboard backrests in the
second row of seats:
• Pull up the handle (1), hold it up, and tilt the
backrest forward to move the seat.
• Return the backrest to the upright position
to ...
Jump starting
Connecting the jumper cables
Follow these instructions to jump start your
vehicle's dead battery or to jump start another
vehicle's dead battery using your vehicle. If the
12-volt auxiliary b ...
Erasing HomeLink Buttons
To erase programming from the three Home-
Link buttons (individual buttons cannot be
erased but can be “reprogrammed” as outlined
below), follow the step noted:
1. Press and hold the two outer H ...
