General information


Location of the side impact (SIPS) airbags (front
seats only)
As an enhancement to the structural side impact protection built into your vehicle, it is also equipped with Side Impact Protection System (SIPS) airbags.
The SIPS airbag system is designed to help increase occupant protection in the event of certain side impact collisions. The SIPS airbags are designed to deploy only during certain side-impact collisions, depending on the crash severity, angle, speed and point of impact.

Driver's side SIPS airbag

Passenger's side SIPS airbag
SIPS airbag deployment (one airbag) occurs only on the side of the vehicle affected by the impact. The airbags are not designed to deploy in all side impact situations.
NOTE
SIPS airbag deployment (one airbag) occurs
only on the side of the vehicle affected by
the impact. The airbags are not designed to
deploy in all side impact situations.
Components in the SIPS airbag system
This SIPS airbag system consists of a gas generator, the side airbag modules built into the outboard sides of both front seat backrests, and electronic sensors/wiring.
WARNING
• The SIPS airbag system is a supplement
to the structural Side Impact Protection
System and the three-point seat
belt system. It is not designed to deploy
during collisions from the front or rear of
the vehicle or in rollover situations.
• The use of seat covers on the front seats
may impede SIPS airbag deployment.
• No objects, accessory equipment or
stickers may be placed on, attached to
or installed near the SIPS airbag system
or in the area affected by SIPS airbag
deployment.
• Never try to open or repair any components
of the SIPS airbag system. This
should be done only by a trained and
qualified Volvo service technician.
• In order for the SIPS airbag to provide
its best protection, both front seat
occupants should sit in an upright position
with the seat belt properly fastened.
• Failure to follow these instructions can
result in injury to the occupants of the
vehicle in the event of an accident.
See also:
Arming the alarm
Press the Lock button on the remote key. One long flash of the turn signals
will confirm that the alarm is armed.
Alarm confirmation settings can be changed in MY CAR, under Car settings
- ...
Engine and cooling system
Under special conditions, for example when driving in hilly terrain, extreme
heat or with heavy loads, there is a risk that the engine and cooling system will
overheat. Proceed as follows to avoid ...
Operation
The seats can be adjusted for a short period
after unlocking the door with the remote control
without the key in the ignition slot. Seat
adjustment is normally made when the ignition
is on and ...
