Replacing high/low beams/turn signal/parking light bulbs
WARNING
• The engine should not be running when
changing bulbs.
• If the engine has been running just prior
to replacing bulbs in the headlight housing,
please keep in mind that components
in the engine compartment will be
hot.
WARNING
Active Bending Lights - due to the high
voltage used by these headlights, these
bulbs should only be replaced by a trained
and qualified Volvo service technician.
The entire lamp housing must be lifted out when replacing these bulbs.
To lift out the lamp housing:
1. Switch off the ignition.
2. Open the hood.
3. Pull up the retaining pins (see the illustration).
4. Lift out the lamp housing.
See also:
Checking tire pressure
Cold tires
Inflation pressure should be checked when the tires are cold.
The tires are considered to be cold when they have the same temperature as the
surrounding (ambient) air.
This temperature ...
Introduction
Distance Alert is part of Adaptive Cruise Control and is a function that provides
information about the time interval to the vehicle ahead.
Distance Alert is active at speeds above approximately 18 ...
Cleaning the brake discs
Coatings of dirt and water on the brake discs
may result in delayed brake function. This delay
is minimized by cleaning the brake linings.
Cleaning the brake pads is advisable in wet
weather, p ...