Returning the spare wheel to the storagecompartment
1. Use the crank (turn it counterclockwise) to
lower the spare wheel's retaining cable.
2. Pass the toggle at the end of the cable
through the center hole in the spare wheel.
Pivot the toggle 90 degrees so that when
raised, the wheel will rest on the toggle.
3. Retract the retaining cable slightly by
slowly turning the crank clockwise several
times.
4. Position the wheel so that it is not obstructed
by components in the exhaust system.
5. Continue to raise the wheel by turning the
crank clockwise. Raise the wheel a little bit
at a time and guide it around the rear axle
until it is securely seated in the storage
area.
6. When it is no longer possible to turn the
crank any further, check that the spare
wheel is securely in position in the storage
compartment.
See also:
Scan
This function plays the first ten seconds of each track/audio file. To start
scanning:
1. Press OK/MENU.
2. Turn TUNE to Scan.
> The first ten seconds of each track/ audio file will be played. ...
Removing the cover to access the bulbs
NOTE
Before starting to replace a bulb, see page 306.
1. Loosen the cover's four retaining screws with the tool (1) provided in the
vehicle's tool kit (see page 290). The screws sho ...
Setting a speed
Once ACC has been put in standby mode, use the
or
buttons to store (set) the vehicle's
current speed. This puts the system in active mode. The set speed, for example 55
mph, is shown in th ...