See also:

Replacing the daytime running lightbulb (models with Active BendingLights only)
1. Remove the rubber cover over the bulb by pulling it off. 2. Turn the bulb holder counterclockwise and pull it out of the headlight housing. 3. Remove the connector from the bulb unit by pres ...

Electrical system
General information 12 volt system with a voltage-regulated alternator. Single pole system in which the chassis and engine block are used as conductors. The negative terminal is connected to the ...

Returning to mode I from mode II
With the remote key fully pressed into the ignition slot, press START/STOP ENGINE briefly. ...