Reprogramming a Single HomeLinkButton
1. Press and hold the desired HomeLink button.
DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the Home- Link button, proceed with “Programming” - step 1.
For questions or comments, contact HomeLink at: www.homelink.com or 1–800–355–3515.
This device complies with FCC rules part 15 and Industry Canada (IC) RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference that may be received including interference that may cause undesired operation.
NOTE
The transmitter has been tested and complies
with FCC and IC rules. Changes or
modifications not expressly approved by
the party responsible for compliance could
void the user’s authority to operate the
device.
See also:
Power steering fluid
Check the level frequently. The fluid does not require changing. The fluid level
must be between the MIN and MAX marks. For capacities and recommended fluid grade,
see page 341.
WARNING
I ...
Symbols in the main instrument panel
Indicator and warning symbols
Other information symbols
Information symbols in the center
console display
Information symbols in the ceiling
console
...
Power door mirrors
Door mirror controls
Adjusting
1. Press the L button for the left door mirror or the R button for the right
door mirror. The light in the button comes on.
2. Adjust the position with the joysti ...