High/low beam headlights
Continuous high beams
1. Turn the ignition key to position II.
2. With the light switch in position ,
(see
page 67) pull the turn signal lever toward
the steering wheel to toggle between high
and low beams.
High beam flash
1. Turn the ignition key to position II.
2. Pull the turn signal lever to position (3). The
high beams will remain on until the lever is
released.
Home safe lighting
When leaving your vehicle at night, home safe lighting can illuminate the area in front of the vehicle.
1. Remove the key from the ignition switch.
2. Pull the turn signal lever as far as possible
toward the steering wheel and release it.
3. Exit the vehicle and lock the doors.
The headlights and parking lights will illuminate and remain on for 301, 60 or 90 seconds. The time interval can be changed by a trained and qualified Volvo service technician.
See also:
Heated rear seats
Heat control for the outboard seating positions is done in the same way as for
the front seats. ...
Operation
Chassis settings
Use the buttons in the center console to
change setting. The setting in use when the
engine is switched off is activated the next time
the engine is started. ...
Rain sensor
The rain sensor automatically regulates wiper
speed according to the amount of water on the
windshield. The sensitivity of the rain sensor
can be adjusted moving the thumb wheel up (the wipers w ...