Re-installing the wheel
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten handtight. Using the lug wrench, tighten crosswise until all nuts are snug.
4. Lower the vehicle to the ground and alternately tighten the bolts crosswise to 103 ft. lbs. (140 Nm).
5. Install the wheel cover (where applicable). The opening in the wheel cover for the tire's inflation valve must be positioned over the valve.
See also:
Operation
Chassis settings
Use the buttons in the center console to
change setting. The setting in use when the
engine is switched off is activated the next time
the engine is started. ...
Common functions: Remote key/Personal Car Communicator (PCC)
Personal Car Communicator (PCC)
...
Introduction
The laminated panoramic roof is divided into
two sections.
• The rear glass section is fixed in place and
cannot be moved.
• The front glass section can be slid horizontally
to the open or clo ...