Operating DAC
Certain settings can be made from the menu system controlled from the center instrument panel.
The current system status can be checked on the trip computer’s display by using the buttons on the left steering wheel lever.
1 - Thumb wheel. Turn this wheel until Driver Alert is displayed. The second line shows the alternatives Off, Driver Alert Standby <40 mph (Driver Alert Standby <65 km/ h), Unavailable or [-----], i.e., the number of bars.
2 - READ button. Confirms and erases a message in the display.
Activating DAC
Press MY CAR in the center instrument panel and go to Car settings Driver Alert and select On. See page 133 for more information on the menu system.
The function is activated when the vehicle exceeds a speed of 40 mph (65 km/h). The display will show level markings of 1–5 bars, where a low number of bars indicates erratic driving. A high number of bars indicates stable driving. If the vehicle is being driven erratically, the driver will be alerted by an audible signal and the message Driver Alert, Time for a break is displayed. The warning will be repeated after a short time if the driving pattern remains the same.
WARNING
- An alert should be taken seriously since it is sometimes difficult for a driver to realize that he/she is fatigued.
- In the event of a warning or if the driver feels fatigued, stop as soon as possible in a safe place and rest.
See also:
Paths
The current menu level is displayed at the upper right of the center console
display. Menu paths are displayed as follows, for example:
The following is an example of how to set a function in the ...
Introduction
Distance Alert is part of Adaptive Cruise Control
and is a function that provides information
about the time interval to the vehicle ahead.
Distance Alert is active at speeds above
approximatel ...
Cleaning floor mats
The floor mats should be vacuumed or brushed
clean regularly, especially during winter when
they should be taken out for drying. Spots on
textile mats can be removed with a mild detergent.
For ...