Activating/deactivating warning signals
The collision warning system’s visual signals are activated automatically when the engine is started if the collision warning system is switched on.
The audible warning signal can be activated/ deactivated by pressing MY CAR on the center console control panel and going to Settings Car settings Driver support systems Warning sound if risk of collision.
See also:
Inflation pressure
Tire inflation pressure table
The following tire pressures are recommended by Volvo for your vehicle. Refer
to the tire inflation placard (see page 273 for its location) for information specific
...
Operation
Controls and display
1 - Resume previous settings, increase speed (each additional press increases
speed by 2 - 1 mph (approximately 2 km/h). 3 - Standby mode on/off 4 - Set time
interval 5 ...
Limitations
Strong sunlight, reflections, extreme light contrasts,
the use of sunglasses, or if the driver is
not looking straight ahead may make the visual
warning signal in the windshield difficult to see ...