Reprogramming a Single HomeLink Button
To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the Home- Link button, proceed with “Programming” - step 1.
For questions or comments, contact HomeLink at: www.homelink.com or 1–800–355–3515.
This device complies with FCC rules part 15 and Industry Canada (IC) RSS-210. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference that may be received including interference that may cause undesired operation.
NOTE
The transmitter has been tested and complies with FCC and IC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.
See also:
Skip options
This function is used to remove a channel from
the list of available channels.
Skipping a channel
1. Press OK/MENU.
2. Scroll to the Advanced settings menu.
3. Press OK/MENU to enter the Skip
...
Turning off the accessory alarm sensors
In certain situations it may be desirable to turn off the accessory inclination
and movement alarm sensors if, for example, you drive your vehicle onto a ferry
where the rocking of the boat could ...
Setting a speed
Use the or
buttons set the vehicle's current
speed. The set speed is shown in the display.
NOTE
Cruise control cannot be engaged at
speeds below 20 mph (30 km/h). ...