Inserting and removing the remote key
Ignition slot with remote key and START/STOP ENGINE button.
Inserting the remote key1
Holding the end of the remote key with the base of the key blade, insert the remote key into the ignition slot as shown in the illustration and press it in as far as possible (past the detent).
CAUTION
Foreign objects in the ignition slot can impair function or cause damage.
Removing the remote key
The remote key can be removed from the ignition slot by pulling it out.
Ignition modes
Ignition mode 0
Insert the remote key in the ignition slot and press it in as far as possible1.
Ignition mode I
NOTE
To access ignition modes I or II without starting the engine, the brake pedal must not be depressed.
With the remote key fully pressed into the ignition slot1, press START/STOP ENGINE briefly.
Ignition mode II
With the remote key fully pressed into the ignition slot1, press START/STOP ENGINE for approximately 2 seconds.
Returning to mode I from mode II
With the remote key fully pressed into the ignition slot1, press START/STOP ENGINE briefly. Returning to mode 0 from mode I Open the driver's door.
See also:
Indicator and warning symbols
Low oil pressure
If the light comes on while driving, stop the vehicle, stop the engine immediately,
and check the engine oil level. If the oil level is normal and the light stays on
after rest ...
Tailgate wiper/washer
A section of the switch
O Neutral position: The wiper is switched
off
B Normal (continuous) wiping: Press the
lower section of the switch
Move the lever forward to start the tailgate
washer. A ...
Securing cargo
As a safety precaution, all cargo in your vehicle
should be securely anchored to keep it from
being thrown forward in the event of sudden
braking, etc. The vehicle is equipped with eyelets
in th ...