Re-installing the wheel
1. Clean the contact surfaces on the wheel and hub.
2. Lift the wheel and place it on the hub.
Tighten the lug nuts
3. Install the wheel nuts and tighten handtight.
Using the lug wrench, tighten crosswise until all nuts are snug.
4. Lower the vehicle to the ground and alternately tighten the bolts crosswise to 103 ft. lbs. (140 Nm).
5. Install the wheel cover (where applicable).
The opening in the wheel cover for the tire's inflation valve must be positioned over the valve.
See also:
Volume control
Turn the knob (2) clockwise or counterclockwise
to raise or lower the volume. The volume
control is electronic and has no end position.
Volume can also be raised (+) or lowered (–)
using the ste ...
Cruise control
Steering wheel-mounted controls and display
1 - Standby mode 2 - Resume set speed 3 - Deactivating 4 - Activate/set
speed 5 - Set speed indicator (parentheses indicate standby mode)
Engaging ...
Fuse box in the passenger compartment, behind the plastic cover, driver's
side
This fuse box is located behind the plastic
cover below the steering wheel. When replacing
a blown fuse, be sure to replace it with a
new one of the same color and amperage (written
on the fuse) ...