Installing the ball holder
1. If necessary, remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch assembly.
2. Slide the ball holder into the hitch assembly.
3. Align the hole in the ball holder with the one in the hitch assembly.
4. Slide the locking bolt through the hitch assembly/ball holder.
5. Insert the cotter pin in the hole at the end of the locking bolt.
See also:
Setting a time interval
Controls and display
3 - Time interval: Increase/decrease
6 - Time interval: On, while it is being set
7 - Time interval: On, after it has been set
Press to increase the interval or
to decrea ...
Inflatable Curtain
The Inflatable Curtain (IC)
This system consists of inflatable curtains
located along the sides of the roof liners,
stretching from the front side windows to the
rear edge of the rear side windo ...
Activating/deactivating park assist
The system is activated automatically when the
vehicle is started.
• Press the Park assist button on the center
console (see page 64) to temporarily deactivate
the system(s). The indicator light ...