Ignition modes and electrical current to RSE
RSE can be activated with the ignition in modes I or II (and when the engine is running).
See page 82 for detailed information about the various ignition modes. If a film is being played, it will stop momentarily while the engine is being started and will resume when the engine is running.
NOTE
Using RSE for more than approx.
10 minutes when the engine is not running
will drain the vehicle's battery and may
make the engine difficult or impossible to
start.
A message will be displayed on the screen
if the battery's charge level becomes too
low.
See also:
Activating/deactivating warning signals
The collision warning system’s visual signals are activated automatically when
the engine is started if the collision warning system is switched on.
The audible warning signal can be activated/ dea ...
Replacing fuses
There are relay/fuse boxes located in the engine compartment, the passenger compartment,
and the trunk.
If an electrical component fails to function, this may be due to a blown fuse.
The easiest ...
Keyless drive
Vehicles equipped with the optional Personal
Car Communicator have the keyless drive
function, see page 63 for detailed information. ...