Removing a paired device

1. In Bluetooth mode, press OK/MENU.
2. Turn TUNE to Remove Bluetooth device and press OK/MENU.
3. Select the device to be removed by turning TUNE and confirm by pressing OK/ MENU.
> A question asking if you would like to remove the device will be displayed.
4. Press OK/MENU to confirm or EXIT to cancel.
See also:
Tire pressure monitoring light
The tire pressure monitoring
system uses sensors
mounted in the tire valves to check inflation
pressure levels. When the vehicle is moving
at a speed of approximately 20 mph
(30 km/h) or faster, ...
Introduction
The HomeLink1 Wireless Control System provides
a convenient way to replace up to three
hand-held radio-frequency (RF) transmitters
used to activate devices such as gate operators,
garage door op ...
Ringing volume
In phone mode, go to Phone menu
Phone
settings
Sounds and volume
Ring
volume and adjust the volume by turning
VOL. Save the setting by pressing EXIT. ...
