Introduction
The Driver Alert System is designed to help a driver who may be becoming fatigued or who is inadvertently leaving the lane.
The Driver Alert System consists of two different functions that can be switched on together or separately.
• Driver Alert Control (DAC)
• Lane Departure Warning (LDW), see
page 183
When one or both of the functions has been switched on, it is in standby mode and is activated when the vehicle exceeds a speed of 40 mph (65 km/h).
The function deactivates if the vehicle's speed goes under 37 mph (60 km/h).
Both functions use a camera that is dependent on the road/lane being clearly marked by painted lines on each side.
WARNING
The Driver Alert System does not function in
all situations and is designed to be a supplementary
aid. It is not, however, intended
to replace the driver’s attention and judgement.
See also:
Erasing HomeLink Buttons
To erase programming from the three Home- Link buttons (individual buttons cannot
be erased but can be “reprogrammed” as outlined below), follow the step noted:
1. Press and hold the two outer Home ...
Tire designations
Information on the sidewall
Federal law mandates that tire manufacturers
place standardized information on the sidewall
of all tires (see the illustration).
The following information is listed ...
Ringing tones
The hands-free system’s integrated ringing
tones can be selected in Phone menu
Phone settings
Sounds and volume
Ring signals
Ring signal 1, etc.
NOTE
The connected cell phone’s rin ...